First introduced to the mini-club line-up in 1977 the 8994 transfer table would remain unchanged in design until 2002 when it was upgraded with a 5 pole motor and the item number was extended by a ‘1’. From 2003 until 2012 the 89941 transfer table was available with a few packaging changes including white versus blue transformer and controller plus a five pole motor. Manufactured throughout its long history in Italy the transfer table is a very well designed and precision accessory for mini-club, it could be used on a layout for modeling steam and diesel, but it could also be accessorized with catenary for electric locos.

I have seen many early and late transfer tables and all were in excellent working condition owing to the excellent design and manufacturing.

The one and only issue with the transfer table 89941 that is easily overcome has to do with delivery specs, three times 89941 was delivered to a local dealer from Walthers and each was afflicted with the same issue: motor housing top plate separation and subsequently gearing detached along with operators’ cabin. No fear, I was able to easily put each back together again. Probably poor packing and shipping from Walthers to Pennsylvania shook things up a bit, but the problem was easily mitigated, and I wanted to share brief notes on the motor housing for new and old transfer table fixes, repairs and restorations.

The motor housing on the transfer table is easily accessed by slipping off the operators’ cabin and then gently working off the top plate of the motor housing which is held in place by clips. Inside the motor housing three sets of gears and the motor. If you need to remove hardened oil simply remove the vertical gear and top gearing to connects with motor and soak in original (blue) Windex, leave motor and second gear in place and with careful use of toothpick, tweezers and very small cleaning cloth remove dirt and hardened oil from the inside of motor housing. Don’t obsess here, normal loco dirt and debris such hair do not afflict this part, careful not to add lint to the housing by cleaning.

To reassemble the motor housing locate mounting hole for vertical gear in base of motor housing (see shiny brass part with hole in base), worm drive end of gear sits in this hole. Note: worm gears align with regular gears only, they do not function together. Large gear is correctly installed on top engaged with worm gear (bushing on each end of top gear that engages with motor allow it to move freely, double check this gear is properly installed before proceeding). Before attaching top plate locate hole with brass bushing, this hole will align with top of vertical gear. Lastly slide on top plate and test.

Underside of top plate with brass bushing, top of vertical gear sits within the bushing.

Everything fits correctly when the motor housing has no gaps.

Note: bridge only moves with power applied when gearing is properly installed, it will not move freely unless the vertical gear is removed from the motor housing.

Don’t be afraid to buy the transfer table used, I have never seen one that can’t be restored with a simple cleaning or realignment of the bridge and those include some late 1970’s examples.

Good luck and happy railroading. Stay tuned for the next post, an exciting loco shed to go with the transfer table has just been released!

Archistories ARC-104171:

Siding: realistic modeling might include weathering of the bridge and attaching corrugated steel in the form of laser cut cardstock to the roof of the operators’ cabin.