Faller 282781: Kleinstadthauser “Provincial Houses”

Faller’s two recent laser cut building kits offer modelers residential building types including the large townhouse (282 780) and small townhouses (282781). The latter Faller describes as Provincial Houses”. For this post the 282781 kit will be featured, it is essentially 4 separate building kits with 4 distinct designs including open timber, stucco, terracotta tile roof and slate roof. One pair with terracotta tile roofs and one pair with slate roofing.

Parts are delivered on well labeled sheets along with window masking and window glazing.

Each building is small, so patient assembly of small parts is necessary even with all 4 buildings glued together they are still small compared to a scotch tape dispenser.

Each building is fairly skinny and unfinished on the back side with the intent that like pairs would be glued together giving a two sided building. Likewise the pairs can likewise be glued together.

One can also use these buildings as backdrop thus leaving pairs unglued. There are lots of options including 15 variations on the order of these buildings in relation to each other.

Each roof can be assembled according to instructions but they can also be installed in reverse order, but due to the design of each building type the terracotta roof cannot be used on the building using the slate roof, the terracotta roof sweeps out from the dormers.

This is an adaptable kit that combined in multiples will allow continuous residential blocks to be realized in the context of a large layout. I recommend following the illustration on the box to determine order of assembly, the stucco building without dormers is the easy one the start on first, and the open timber and stucco building will take longer to finish along with the other building with terracotta roof tiles.

The instructions are very good, but I would add a few notes: 1. get acquainted with the dormers and how they assemble before gluing, the long side of side frames attach to roof.  2. roof sheathing has a correct orientation with a top and bottom, have a good look before gluing and imagine what this looks like in real life.  3. The pair of black roof buildings need to be prepped to insure flush assembly: with a sharp razor blade trim back the roof framing to make flush with the backside of each building, test for the two buildings join evenly before gluing. 4. stucco sections are individually cut out and glued in place in the open timber framework which is real wood, this step is time consuming but install no more than two pieces at a time to prevent loss of parts. 5. Another note on open timber, the wood is tinted using a water soluble color, the water soluble glue you use will likely allow the wood tint to bleed into the white cardboard filler sections: no worries the prototypical buildings in Germany have these qualities in real life. In general imperfections will add to the realism of a stucco building. 282780 and 282781 are very good kits designed to be used in multiplies and thus one can build continuous city blocks as can be seen in Europe.

Finished project with all four units glued together:

Note: there is a seam that runs vertically along each end, my plan is to assemble 3 more kits for a long running block of these buildings, and I plan to add a strip of similarly tinted card stock to cover the seam thereby suggesting a shoring line that can be seen on some buildings similar to this type in the United States. Another option I might try is applying a latex primer over each finished end and repainting in a suitable color, but this option might look too different as for surface texture, it might be better left alone (?).

Here are the finished 282780 + 282781. The impressive scale of these buildings are accentuated with multiple units, they will surely add interest on any layout.